Users Guide

– To display information about Open Shortest Path First (OSPF) routes, enter ospf.
– To display information about Routing Information Protocol (RIP), enter rip.
– To display information about static IPv6 routes, enter static.
– To display information about an IPv6 Prex lists, enter list and the prex-list name.
Example of the show ipv6 route summary Command
Example of the show ipv6 route Command
Example of the show ipv6 route static Command
Dell#show ipv6 route summary
Route Source Active Routes Non-active Routes
connected 5 0
static 0 0
Total 5 0
Dell#show ipv6 route
Codes: C - connected, L - local, S - static, R - RIP,
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,
Gateway of last resort is not set
Destination Dist/Metric, Gateway, Last Change
-----------------------------------------------------
C 2001::/64 [0/0]
Direct, Gi 1/1, 00:28:49
C 2002::/120 [0/0]
Direct, Gi 1/1, 00:28:49
C 2003::/120 [0/0]
Direct, Gi 1/1, 00:28:49
Dell#show ipv6 route static
Destination Dist/Metric, Gateway, Last Change
-----------------------------------------------------
S 8888:9999:5555:6666:1111:2222::/96 [1/0]
via 2222:2222:3333:3333::1, Gi 9/1, 00:03:16
S 9999:9999:9999:9999::/64 [1/0]
via 8888:9999:5555:6666:1111:2222:3333:4444, 00:03:16
Showing the Running-Conguration for an Interface
To view the conguration for any interface, use the following command.
• Show the currently running conguration for the specied interface.
EXEC mode
show running-config interface type {slot/port}
Enter the keyword interface then the type of interface and slot/port information:
– For a 10/100/1000 Ethernet interface, enter the keyword GigabitEthernet then the slot/ port information.
– For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then the slot/ port information.
– For the Management interface on the RPM, enter the keyword ManagementEthernet then the slot/port information.
– For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
Example of the show running-config interface Command
Dell#show run int gi 2/2
!
IPv6 Routing
431