Users Guide
• All VLANS must be in Layer 2 mode.
• You can only add ring nodes to the VLAN.
• A control VLAN can belong to one FRRP group only.
• Tag control VLAN ports.
• All ports on the ring must use the same VLAN ID for the control VLAN.
• You cannot congure a VLAN as both a control VLAN and member VLAN on the same ring.
• Only two interfaces can be members of a control VLAN (the Master Primary and Secondary ports).
• Member VLANs across multiple rings are not supported in Master nodes.
To create the control VLAN for this FRRP group, use the following commands on the switch that is to act as the Master node.
1 Create a VLAN with this ID number.
CONFIGURATION mode.
interface vlan vlan-id
VLAN ID: from 1 to 4094.
2 Tag the specied interface or range of interfaces to this VLAN.
CONFIG-INT-VLAN mode.
tagged interface slot/ port {range}
• For a 10/100/1000 Ethernet interface, enter the keyword GigabitEthernet then the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
Slot/Port, Range: Slot and Port ID for the interface. Range is entered Slot/Port-Port.
3 Assign the Primary and Secondary ports and the control VLAN for the ports on the ring.
CONFIG-FRRP mode.
interface primary int slot/port secondary int slot/port control-vlan vlan id
• For a 10/100/1000 Ethernet interface, enter the keyword GigabitEthernet then the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then the slot/port information.
• For a SONET interface, enter the keyword sonet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
Slot/Port, Range: Slot and Port ID for the interface. Range is entered Slot/Port-Port.
VLAN ID: The VLAN identication of the control VLAN.
4 Congure the Master node.
CONFIG-FRRP mode.
mode master
5 Identify the Member VLANs for this FRRP group.
CONFIG-FRRP mode.
member-vlan vlan-id {range}
VLAN-ID, Range: VLAN IDs for the ring’s member VLANS.
6 Enable FRRP.
CONFIG-FRRP mode.
Force10 Resilient Ring Protocol (FRRP)
325