Users Guide

Dell(conf)#route-map force deny 30
Dell(config-route-map)#match tag 1000
Conguring Match Routes
To congure match criterion for a route map, use the following commands.
• Match routes whose next hop is a specic interface.
CONFIG-ROUTE-MAP mode
match interface interface
The parameters are:
– For a Loopback interface, enter the keyword loopback then a number between zero (0) and 16383.
– For a 10-Gigabit Ethernet interface, enter the keyword tengigabitEthernet then the slot/port information.
– For a VLAN, enter the keyword vlan then a number from 1 to 4094.
• Match destination routes specied in a prex list (IPv4).
CONFIG-ROUTE-MAP mode
match ip address prefix-list-name
• Match next-hop routes specied in a prex list (IPv4).
CONFIG-ROUTE-MAP mode
match ip next-hop {access-list-name | prefix-list prefix-list-name}
• Match source routes specied in a prex list (IPv4).
CONFIG-ROUTE-MAP mode
match ip route-source {access-list-name | prefix-list prefix-list-name}
• Match routes with a specic value.
CONFIG-ROUTE-MAP mode
match metric metric-value
• Match routes specied as internal or external to OSPF, ISIS level-1, ISIS level-2, or locally generated.
CONFIG-ROUTE-MAP mode
match route-type {external [type-1 | type-2] | internal | level-1 | level-2 | local }
• Match routes with a specic tag.
CONFIG-ROUTE-MAP mode
match tag tag-value
To create route map instances, use these commands. There is no limit to the number of match commands per route map, but the
convention is to keep the number of match lters in a route map low.
Set commands do not require a corresponding match command.
Conguring Set Conditions
To congure a set condition, use the following commands.
• Generate a tag to be added to redistributed routes.
CONFIG-ROUTE-MAP mode
set automatic-tag
• Specify an OSPF area or ISIS level for redistributed routes.
CONFIG-ROUTE-MAP mode
Access Control Lists (ACLs)
133