Deployment Guide

You can congure virtual link trunking (VLT) peer nodes as rendezvous points (RPs) in a Protocol Independent Multicast (PIM) domain.
If the VLT node elected as the designated router fails, trac loss occurs until another VLT node is elected the designated router.
VLT Multicast
VLT multicast provides multiple alternate paths for resiliency against link and node failures.
This feature supports inter-server multicast communication between top-of-rack (ToR) switches using an inter-VLAN Layer 3 routing
protocol (for example, PIM, IS-IS, or OSPF). It also provides trac resiliency during multicast routing convergence after failure without
disrupting or altering multicast routing behavior.
Layer 2 protocols from the ToR to the server are intra-rack and inter-rack. No spanning tree is required, but interoperability with spanning
trees at the aggregation layer is supported. Communication is active-active, with no blocked links. MAC tables are synchronized between
VLT nodes for bridging and IGMP snooping can be enabled.
VLT multicast is also scalable, so additional racks can be implemented in an existing system to provide additional resiliency and resources to
accommodate an increased need or to anticipate future growth. You can enable VLT unicast and multicast routing across multiple
congurations using VLT links. Protocols such as BGP, OSPF, and PIM are compatible with VLT multicast.
Important Points to Remember
• You cannot congure a VLT node as a rendezvous point (RP), but any PIM-SM compatible VLT node can serve as a designated router
(DR).
• You can only use one spanned VLAN from a PIM-enabled VLT node to an external neighboring PIM router.
• If you connect multiple spanned VLANs to a PIM neighbor, or if both spanned and non-spanned VLANs can access the PIM neighbor,
ECMP can cause the PIM protocol running on each VLT peer node to choose a dierent VLAN or IP route to reach the PIM neighbor.
This can result in issues with multicast route syncing between peers.
• Both VLT peers require symmetric Layer 2 and Layer 3 congurations on both VLT peers for any spanned VLAN.
• For optimal performance, congure the VLT VLAN routing metrics to prefer VLT VLAN interfaces over non-VLT VLAN interfaces.
• When using factory default settings on a new switch deployed as a VLT node, packet loss may occur due to the requirement that all
ports must be open.
• You can enable ECMP on VLT nodes using VLT unicast; however, ECMP is not compatible on VLT nodes using VLT multicast. You must
use a single VLAN.
Conguring VLT Multicast
To enable and congure VLT multicast, follow these steps.
1 Enable VLT on a switch, then congure a VLT domain and enter VLT-domain conguration mode.
CONFIGURATION mode
vlt domain domain-id
2 Enable peer-routing.
VLT DOMAIN mode
peer-routing
3 Congure the multicast peer-routing timeout.
VLT DOMAIN mode
multicast peer-routing—timeout value
value: Specify a value (in seconds) from 1 to 1200.
870
Virtual Link Trunking (VLT)