Deployment Guide

Troubleshooting VLT
To help troubleshoot dierent VLT issues that may occur, use the following information.
NOTE: For information on VLT Failure mode timing and its impact, contact your Dell Networking representative.
Table 79. Troubleshooting VLT
Description Behavior at Peer Up Behavior During Run Time Action to Take
Bandwidth monitoring A syslog error message and an
SNMP trap is generated when
the VLTi bandwidth usage goes
above the 80% threshold and
when it drops below 80%.
A syslog error message and an
SNMP trap is generated when
the VLTi bandwidth usage goes
above its threshold.
Depending on the trac that is
received, the trac can be
ooaded inVLTi.
Domain ID mismatch
The VLT peer does not boot up.
The VLTi is forced to a down
state.
A syslog error message and an
SNMP trap are generated.
The VLT peer does not boot up.
The VLTi is forced to a down
state.
A syslog error message and an
SNMP trap are generated.
Verify the domain ID matches on
both VLT peers.
Dell Networking OS Version
mismatch
A syslog error message is
generated.
A syslog error message is
generated.
Follow the correct upgrade
procedure for the unit with the
mismatched Dell Networking OS
version.
Remote VLT port channel status N/A N/A Use the show vlt detail
and show vlt brief
commands to view the VLT port
channel status information.
System MAC mismatch A syslog error message and an
SNMP trap are generated.
A syslog error message and an
SNMP trap are generated.
Verify that the unit ID of VLT
peers is not the same on both
units and that the MAC address
is the same on both units.
Unit ID mismatch
The VLT peer does not boot up.
The VLTi is forced to a down
state.
A syslog error message is
generated.
The VLT peer does not boot up.
The VLTi is forced to a down
state.
A syslog error message is
generated.
Verify the unit ID is correct on
both VLT peers. Unit ID numbers
must be sequential on peer units;
for example, if Peer 1 is unit ID
“0”, Peer 2 unit ID must be “1’.
Version ID mismatch A syslog error message and an
SNMP trap are generated.
A syslog error message and an
SNMP trap are generated.
Verify the Dell Networking OS
software versions on the VLT
peers is compatible. For more
information, refer to the Release
Notes for this release.
VLT LAG ID is not congured on
one VLT peer
A syslog error message is
generated. The peer with the
VLT congured remains active.
A syslog error message is
generated. The peer with the
VLT congured remains active.
Verify the VLT LAG ID is
congured correctly on both VLT
peers.
VLT LAG ID mismatch
The VLT port channel is brought
down.
The VLT port channel is brought
down.
Perform a mismatch check after
the VLT peer is established.
836 PMUX Mode of the IO Aggregator