Deployment Guide

storm-control broadcast packets_per_second in
• Congure the percentage of multicast trac allowed on C-Series or S-Series interface (ingress only) network only.
INTERFACE mode
storm-control multicast packets_per_second in
• Shut down the port if it receives the PFC/LLFC packets more than the congured rate.
INTERFACE mode
storm-control pfc-llfc pps in shutdown
NOTE: PFC/LLFC storm control enabled interface disables the interfaces if it receives continuous PFC/LLFC packets. It
can be a result of a faulty NIC/Switch that sends spurious PFC/LLFC packets.
Conguring Storm Control from CONFIGURATION Mode
To congure storm control from CONFIGURATION mode, use the following command.
You can congure storm control for ingress trac in CONFIGURATION mode. Do not apply per-virtual local area network (per-VLAN)
quality of service (QoS) on an interface that you have enabled storm-control (either on an interface or globally).
• Congure storm control.
CONFIGURATION mode
• Congure the packets per second of broadcast trac allowed in the network.
CONFIGURATION mode
storm-control broadcast packets_per_second in
• Congure the packets per second (pps) of multicast trac allowed on C-Series and S-Series networks only.
CONFIGURATION mode
storm-control multicast packets_per_second in
• Congure the packets per second of unknown-unicast trac allowed in or out of the network.
CONFIGURATION mode
storm-control unknown-unicast [packets_per_second in
782
Storm Control