Deployment Guide

• kern (for kernel messages)
• local0 (for local use)
• local1 (for local use)
• local2 (for local use)
• local3 (for local use)
• local4 (for local use)
• local5 (for local use)
• local6 (for local use)
• local7 (for local use)
• lpr (for line printer system messages)
• mail (for mail system messages)
• news (for USENET news messages)
• sys9 (system use)
• sys10 (system use)
• sys11 (system use)
• sys12 (system use)
• sys13 (system use)
• sys14 (system use)
• syslog (for syslog messages)
• user (for user programs)
• uucp (UNIX to UNIX copy protocol)
Example of the show running-config logging Command
To view non default settings, use the show running-config logging command in EXEC mode.
Dell#show running-config logging
!
logging buffered 524288 debugging
service timestamps log datetime msec
service timestamps debug datetime msec
!
logging trap debugging
logging facility user
logging source-interface Loopback 0
logging 10.10.10.4
Dell#
Synchronizing Log Messages
You can congure the system to lter and consolidate the system messages for a specic line by synchronizing the message output.
Only the messages with a severity at or below the set level appear. This feature works on the terminal and console connections available on
the system.
1 Enter LINE mode.
CONFIGURATION mode
line {console 0 | vty number [end-number]}
Congure the following parameters for the virtual terminal lines:
• number: the range is from zero (0) to 9.
• end-number: the range is from 1 to 8.
76
Management