Deployment Guide

192.161.1.0/24
[120/1] via 29.10.10.12, 00:00:27, Fa 0/0
192.161.1.0/24 auto-summary
192.162.3.0/24
[120/1] via 29.10.10.12, 00:01:22, Fa 0/0
192.162.3.0/24 auto-summary
To disable RIP globally, use the no router rip command in CONFIGURATION mode.
Congure RIP on Interfaces
When you enable RIP globally on the system, interfaces meeting certain conditions start receiving RIP routes.
By default, interfaces that you enable and congure with an IP address in the same subnet as the RIP network address receive RIPv1 and
RIPv2 routes and send RIPv1 routes.
Assign IP addresses to interfaces that are part of the same subnet as the RIP network identied in the network command syntax.
Controlling RIP Routing Updates
By default, RIP broadcasts routing information out all enabled interfaces, but you can congure RIP to send or to block RIP routing
information, either from a specic IP address or a specic interface.
To control which devices or interfaces receive routing updates, congure a direct update to one router and congure interfaces to block
RIP updates from other sources.
To control the source of RIP route information, use the following commands.
• Dene a specic router to exchange RIP information between it and the Dell Networking system.
ROUTER RIP mode
neighbor ip-address
You can use this command multiple times to exchange RIP information with as many RIP networks as you want.
• Disable a specic interface from sending or receiving RIP routing information.
ROUTER RIP mode
passive-interface interface
Adding RIP Routes from Other Instances
In addition to ltering routes, you can add routes from other routing instances or protocols to the RIP process.
With the redistribute command, you can include open shortest path rst (OSPF), static, or directly connected routes in the RIP
process.
To add routes from other routing instances or protocols, use the following commands.
• Include directly connected or user-congured (static) routes in RIP.
ROUTER RIP mode
redistribute {connected | static} [metric metric-value] [route-map map-name]
• metric-value: the range is from 0 to 16.
• map-name: the name of a congured route map.
• Include specic OSPF routes in RIP.
ROUTER RIP mode
670
Routing Information Protocol (RIP)