Deployment Guide

0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 2w4d2h
Dell#
VLAN Interfaces
VLANs are logical interfaces and are, by default, in Layer 2 mode. Physical interfaces and port channels can be members of VLANs.
For more information about VLANs and Layer 2, refer to Layer 2 and Virtual LANs (VLANs).
NOTE: To monitor VLAN interfaces, use Management Information Base for Network Management of TCP/IP-based internets:
MIB-II (RFC 1213).
NOTE: You cannot simultaneously use egress rate shaping and ingress rate policing on the same VLAN.
The Dell Networking OS supports Inter-VLAN routing (Layer 3 routing in VLANs). You can add IP addresses to VLANs and use them in
routing protocols in the same manner that physical interfaces are used. For more information about conguring dierent routing protocols,
refer to the chapters on the specic protocol.
A consideration for including VLANs in routing protocols is that you must congure the no shutdown command. (For routing trac to
ow, you must enable the VLAN.)
NOTE
: You cannot assign an IP address to the default VLAN, which is VLAN 1 (by default). To assign another VLAN ID to the
default VLAN, use the default vlan-id vlan-id command.
To assign an IP address to an interface, use the following command.
• Congure an IP address and mask on the interface.
INTERFACE mode
ip address ip-address mask [secondary]
• ip-address mask: enter an address in dotted-decimal format (A.B.C.D). The mask must be in slash format (/24).
• secondary: the IP address is the interface’s backup IP address. You can congure up to eight secondary IP addresses.
Example of a Conguration for a VLAN Participating in an OSPF Process
interface Vlan 10
ip address 1.1.1.2/24
tagged GigabitEthernet 2/2-13
tagged TenGigabitEthernet 5/0
ip ospf authentication-key Dell force10
ip ospf cost 1
ip ospf dead-interval 60
ip ospf hello-interval 15
no shutdown
!
Loopback Interfaces
A Loopback interface is a virtual interface in which the software emulates an interface. Packets routed to it are processed locally.
Because this interface is not a physical interface, you can congure routing protocols on this interface to provide protocol stability. You can
place Loopback interfaces in default Layer 3 mode.
Interfaces
355