Concept Guide

database-timer
rate-limit
(OPTIONAL) Enter the keywords database-timer rate-limit to display the LSA
throttling timer information.
Command Modes EXEC Privilege
Supported Modes Full—Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the debug ip ospf command shown in the Example below.
Field Description
8:14 Displays the time stamp.
OSPF Displays the OSPF process ID: instance ID.
v: Displays the OSPF version. The system supports version 2 only.
t: Displays the type of packet sent:
• 1 - Hello packet
• 2 - database description
• 3 - link state request
• 4 - link state update
• 5 - link state acknowledgement
l: Displays the packet length.
rid: Displays the OSPF router ID.
aid: Displays the Autonomous System ID.
chk: Displays the OSPF checksum.
aut: States if OSPF authentication is congured. One of the following is listed:
• 0 - no authentication congured
• 1 - simple authentication congured using the ip ospf authentication-key
command
• 2 - MD5 authentication congured using the ip ospf message-digest-key
command
auk: If the ip ospf authentication-key command is congured, this eld displays the
key used.
keyid: If the ip ospf message-digest-key command is congured, this eld displays the
MD5 key
to: Displays the interface to which the packet is intended.
dst: Displays the destination IP address.
netmask: Displays the destination IP address mask.
pri: Displays the OSPF priority
N, MC, E, T Displays information available in the Options eld of the HELLO packet:
Open Shortest Path First (OSPFv2 and OSPFv3) 925