Concept Guide

Multicast

The multicast commands are supported by Dell Networking Operating System (OS).

This chapter contains the following sections:

• IPv4 Multicast Commands

• IPv6 Multicast Commands

Topics:

• IPv4 Multicast Commands

• clear ip mroute

• ip mroute

• ip multicast-limit

• ip multicast-routing

• mtrace

• show ip mroute

• show ip rpf

• IPv6 Multicast Commands

• debug ipv6 mld_host

• ip multicast-limit

IPv4 Multicast Commands

The following section contains the IPv4 multicast commands.

clear ip mroute

Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent multicast (PIM) tree information base,

use the clear ip pim tib command.

Syntax

clear ip mroute {group-address [source-address] | * | snooping}

Parameters

group-address

[source-address]

Enter the multicast group address and source address (if desired), in dotted decimal

format, to clear information on a specic group.

* Enter * to clear all multicast routes.

snooping Enter the keyword snooping to delete multicast snooping route table entries.

Command Modes EXEC Privilege

Supported Modes Full–Switch

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

Multicast 891