Concept Guide

Generate narrow metrics: level-1-2
Accept narrow metrics: level-1-2
Generate wide metrics: none
Accept wide metrics: none
Multi Topology Routing is enabled in transition mode.
Dell#
show isis trac
This command allows you to display IS-IS trac interface information.
Syntax
show isis traffic [interface]
Parameters
interface (OPTIONAL) Identies the interface type slot/port as one of the following:
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
•
For a VLAN, enter the keyword vlan then a number from 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show isis traffic command shown in the following example.
Item Description
Level-1/Level-2
Hellos (sent/rcvd)
Displays the number of Hello packets sent and received.
PTP Hellos (sent/
rcvd)
Displays the number of point-to-point Hellos sent and received.
Level-1/Level-2
LSPs sourced
(new/refresh)
Displays the number of new and refreshed LSPs.
Level-1/Level-2
LSPs ooded
(sent/rcvd)
Displays the number of ooded LSPs sent and received.
Level-1/Level-2
LSPs CSNPs (sent/
rcvd)
Displays the number of CSNP LSPs sent and received.
810 Intermediate System to Intermediate System (IS-IS)