Concept Guide

Defaults Disabled
Command Modes CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
net
To congure an IS-IS network entity title (NET) for a routing process, use this mandatory command. If you did not congure a NET, the IS-
IS process does not start.
Syntax
net network-entity-title
To remove a net, use the no net network-entity-title command.
Parameters
network-entity-title Specify the area address and system ID for an IS-IS routing process. The rst 1 to 13
bytes identify the area address. The next 6 bytes identify the system ID. The last 1 byte is
the selector byte, always identied as zero zero (00). This argument can be applied to an
address or a name.
Defaults Not congured.
Command Modes ROUTER ISIS
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
passive-interface
Suppress routing updates on an interface. This command stops the router from sending updates on that interface.
Syntax
passive-interface interface
To delete a passive interface conguration, use the no passive-interface interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For Loopback interface, enter the keyword loopback then a number from 0 to
16383.
•
For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
Intermediate System to Intermediate System (IS-IS) 797