Concept Guide

capture bgp-pdu neighbor (ipv6)
Enable capture of an IPv6 BGP neighbor packet.
Syntax
capture bgp-pdu neighbor ipv6-address direction {both | rx | tx}
To disable capture of the IPv6 BGP neighbor packet, use the no capture bgp-pdu neighbor ipv6-
address command.
Parameters
ipv6-address Enter the IPv6 address of the target BGP neighbor.
direction {both | rx |
tx}
Enter the keyword direction and a direction — either rx for inbound, tx for
outbound, or both.
Defaults Not congured.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands
capture bgp-pdu max-buer-size — enables route reection between the route reector and the clients.
show capture bgp-pdu neighbor — congures a route reector and clients.
capture bgp-pdu max-buer-size
Set the size of the BGP packet capture buer. This buer size pertains to both IPv4 and IPv6 addresses.
Syntax
capture bgp-pdu max-buffer-size 100-102400000
Parameters
100-102400000 Enter a size for the capture buer.
Defaults 40960000 bytes
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
688 IPv6 Border Gateway Protocol (IPv6 BGP)