Concept Guide

fe80::201:e8ff:fea7:497e
300::1/64
Dell#
Example (tunnel)
Dell#show ipv6 interface tun 1
Tunnel 1 is up, line protocol is up
IPV6 is enabled
Link Local address: fe80::201:e8ff:fea7:497e
Global Unicast address(es):
400::1, subnet is 400::/64 (MANUAL)
Remaining lifetime: infinite
Global Anycast address(es):
Joined Group address(es):
ff02::1
ff02::2
ff02::1:ff00:1
ff02::1:ffa7:497e
ND MTU is 0
ICMP redirects are not sent
DAD is enabled, number of DAD attempts: 3
ND reachable time is 20410 milliseconds
ND base reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND router advertisements are sent every 198 to 600 seconds
ND router advertisements live for 1800 seconds
ND advertised hop limit is 64
IPv6 hop limit for originated packets is 64
IPv6 unicast RPF check is not supported
Dell#
show ipv6 mld_host
Display the IPv6 MLD host counters.
Syntax
show ipv6 mld_host
Command Modes EXEC
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show ipv6 mld-host command shown in the following example.
Field Description
Valid MLD Packets The total number of packets received and sent from the last time the elapsed time was
cleared.
Reports The total number of reports (queries and unsolicited reports generated from joins or
leaves) that have been received or sent.
Leaves The number of Multicast leaves that have been sent.
MLDv1 queries The number of MLDv1 queries that have been received.
MLDv2 queries The number of MLDv2 queries that have been received.
IPv6 Basics 671