Concept Guide
ipv6 control-plane icmp error-rate-limit
Congure the maximum number of ICMP error packets per second that can be sent per second.
Syntax
ipv6 control-plane icmp error-rate-limit {1-200}
To restore the default value, use the no ipv6 control-plane icmp error-rate-limit command.
Parameters
pps Enter the maximum number of error packets generated per second. The range is from 1 to
200, where 0 disables the rate-limiting.
Default 100 pps
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
ipv6 owlabel-zero
Congure system to set the ow label eld in the packets to zero.
Syntax
ipv6 flowlabel-zero
To disable the 0 from being set in the eld and allow the rotocol operations to ll the eld, use the no ipv6
flowlabel-zero command.
Default Disabled
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information If the owlabel value is already set for BGP or SSH, the system defaults to the already congured value. All packets
on the same connection are considered part of the same ow by the system. For new connections, set the new
owlabel to zero.
ipv6 host
Assign a name and IPv6 address the host-to-IPv6 address mapping table uses.
Syntax
ipv6 host name ipv6-address
660 IPv6 Basics