Concept Guide

summary (OPTIONAL) Enter the keyword summary to view a table listing route prexes and the
total number routes which can be entered in to CAM.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show ip cam command shown in the following example.
Field Description
Destination Displays the destination route of the index.
EC Displays the number of equal cost multipaths (ECMP) available for the default route for
non-Jumbo line cards. For Jumbo line cards, displays 0,1 when ECMP is more than eight.
CG Displays 0.
V Displays a 1 if the entry is valid and a 0 otherwise.
C Displays the CPU bit. 1 indicates that a packet hitting this entry is forwarded to the CP or
RP2, depending on Egress port.
V Id Displays the VLAN ID. If the entry is 0, the entry is not part of a VLAN.
Mac Addr Displays the next-hop router’s MAC address.
Port Displays the egress interface. Use the second half of the entry to determine the interface.
For example, in the entry 17cl CP, the CP is the pertinent portion.
• CP = control processor
• Gi = Gigabit Ethernet interface
• Te = 10–Gigabit Ethernet interface
Example
Dell#show ip cam stack-unit 0 port-set 0 10.10.10.10/32 longer-prefixes
Destination EC CG V C VId Mac-Addr Port
----------------- -- -- - ------ --------------------
10.10.10.10 0 0 1 1 0 00:00:00:00:00:00 3f01 CP
Dell#
Usage Information The following describes the show ip cam ecmp-group command shown in the following example.
Field Description
Prex Length Displays the prex-length or mask for the IP address congured on the linecard 0 port
pipe 0.
Current Use Displays the number of routes currently congured for the corresponding prex or mask
on the linecard 0 port pipe 0.
IPv4 Routing 627