Concept Guide

Version Description
8.3.17.0 Supported on the M I/O Aggregator.
debug arp
View information on ARP transactions.
Syntax
debug arp [interface] [count value]
To stop debugging ARP transactions, use the no debug arp command.
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For the Management interface, enter the keyword ManagementEthernet then the
slot/port information. The slot range is from 0 to 1 and the port range is 0.
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
count value (OPTIONAL) Enter the keyword count then the count value. The range is from 1 to
65534.
Defaults none
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To stop packets from ooding the user terminal when debugging is turned on, use the count option.
debug ip dhcp
Enable debug information for DHCP relay transactions and display the information on the console.
Syntax
debug ip dhcp
Parameters
debug ip dhcp To disable debug, use the no debug ip dhcp command.
Defaults Debug disabled
Command Mode EXEC Privilege
Supported Modes All Modes
608 IPv4 Routing