Concept Guide

stack-unit port-group port mode ethernet
Converts the interfaces 9 and 10 from Fibre Channel mode to Ethernet.
Syntax
stack-unit unit number port-group 0 portmode ethernet
To convert the interfaces 9 and 10 from Ethernet to Fibre Channel mode, use the no stack-unit unit
number port-group 0 portmode ethernet.
Parameters
stack-unit Enter the keyword stack-unit followed by a stack member number to select the stack
unit. The range is 0 to 5.
port-group Enter the keyword port-group followed by 0.
portmode ethernet Enter the keyword portmode ethernet to convert the interfaces from Fibre Channel
mode to Ethernet.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.6(0.0) Supported on the FN2210S Aggregator.
vlan tagged (CMC)
Add a Layer 2 interface to a VLAN as a tagged interface.
Syntax
vlan tagged [vlan-id]
To remove a tagged interface from a VLAN, use the no vlan tagged vlan-id command.
Parameters
vlan-id Enter the VLAN ID. The range is from 1 to 4094.
Defaults All interfaces in Layer 2 mode are untagged.
Command Modes INTERFACE
Supported Modes All Modes
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
If the interface belongs to several VLANs, you must remove it from all VLANs to change it to an untagged
interface.
Tagged interfaces can belong to multiple VLANs, while untagged interfaces can only belong to one VLAN at a time.
Interfaces 599