Concept Guide

Codes: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Trunk, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT
tagged
Name: TenGigabitEthernet 2/9
802.1QTagged: True
Vlan membership:
Q Vlans
T 1001
Name: TenGigabitEthernet 2/11
802.1QTagged: True
Vlan membership:
Q Vlans
T 1001
Dell#
Related Commands
show ip interface — displays Layer 3 information about the interfaces.
show interfaces transceiver
Display the physical status and operational status of an installed transceiver. The output also displays the transceiver’s serial number.
Syntax
show interfaces tengigabitethernet slot/port transceiver
Parameters
tengigabitethernet For a 10G interface, enter the keyword tengigabitethernet then the slot/port
information.
NOTE: This command also enables you to view information corresponding to a
range of ports. However, for Open Networking (ON) platforms the notation for
specifying port range in the command is dierent from how you specify in non-
ON platforms.
• For non-ON platforms, you can specify multiple ports as slot/port-range.
For example, if you want to display information corresponding to all ports
between 1 and 4, specify the port range as show interfaces
interface-type 1/1 - 4.
• For ON platforms, you can specify multiple ports as slot/port/[subport]
- slot/port/[subpot]. For example, if you want to display information
corresponding to all ports between 1 and 4, specify the port range as show
interfaces interface-type 1/1/1 - 1/4/1.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM and added support to display the interface congurations
corresponding to a range of ports.
570 Interfaces