Concept Guide

Defaults 299 seconds
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.11.0.0 Introduced on all Dell Networking OS platforms.
Usage Information
The output of the show interfaces command displays the congured rate interval, along with the collected
trac data.
When rate-interval is not congured in the global conguration mode or interface mode, the default value of 299
seconds is applied.
When rate-interval is congured only in the global conguration mode and not in the interface mode, the global
rate-interval value is applied at the interface level also.
When rate-interval is congured at the interface level and not in the global conguration mode, the interface level
rate-interval value is applied for an interface.
When rate interval is congured in both global conguration mode as well as interface mode, then the rate-interval
value congured at interface level is applied as it takes precedence over the global value.
remote-fault-signaling rx
Brings the interface up or down when a Remote Fault Indication (RFI) error is detected.
Syntax
remote-fault-signaling rx {on | off}
Parameters
on Brings the interface up when an RFI error is detected.
o Brings the interface down when an RFI error is detected.
Defaults ON.
Command Modes INTERFACE CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Introduced on the MXL switch.
Usage Information
By default, the switch processes the RFI errors transmitted by remote peers and brings down the interface when
an RFI error is detected.
Example
Dell(conf-if-te-1/3)#remote-fault-signaling rx ?
on Enable
off Disable
560 Interfaces