Concept Guide

Port 0
• auto-negotiation enabled* speed 1000 or auto
• auto-negotiation enabled speed 100
• auto-negotiation disabled speed 100
• auto-negotiation disabled speed 100
• auto-negotiation enabled* speed 1000 or auto
Port 1
• auto-negotiation enabled* speed 1000 or auto
• auto-negotiation enabled speed 100
• auto-negotiation disabled speed 100
• auto-negotiation enabled speed 100
• auto-negotiation disabled speed 100
Link Status Between Port 1 and Port 2
• Up at 1000 Mb/s
• Up at 100 Mb/s
• Up at 100 Mb/s
• Down
• Down
* You cannot disable auto-negotiation when the speed is set to 1000 or auto.
Related Commands
speed (for 1000/10000 interfaces) — sets the link speed to 10, 100, 1000 or auto-negotiate the speed.
portmode hybrid
To accept both tagged and untagged frames, set a physical port or port-channel. A port congured this way is identied as a hybrid port in
report displays.
Syntax
portmode hybrid
To return a port to accept either tagged or untagged frames (non-hybrid), use the no portmode hybrid
command.
Defaults non-hybrid
Command Modes INTERFACE (conf-if-interface-slot/port)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The following describes the interface command shown in the following example. This example sets a port as
hybrid, makes the port a tagged member of VLAN 20, and an untagged member of VLAN 10, which becomes the
native VLAN of the port. The port now accepts:
Interfaces 557