Concept Guide
interface vlan
Congure a VLAN. Congure the default VLAN to enable Static or DCHP IP conguration. You can congure up to 4094 VLANs.
Syntax
interface vlan vlan-id
To delete a VLAN, use the no interface vlan vlan-id command.
Parameters
vlan-id Enter 1 for the default VLAN. Enter a number as the VLAN identier. The range is from 1
to 4096.
Defaults Not congured, except for the default VLAN, which is congured as VLAN 1.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information For more information about VLANs and the commands to congure them, refer to Virtual LAN (VLAN)
Commands.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC/IP ACLs are not supported.
Examples
Dell(conf)#int vlan 1
Dell(conf-if-vl-1)#
Dell(conf)#int vlan 3
Dell(conf-if-vl-3)#
Related commands show vlan — Displays the current VLAN conguration on the switch.
vlan tagged — Adds a Layer 2 interface to a VLAN as a tagged interface.
vlan untagged — Adds a Layer 2 interface to a VLAN as an untagged interface.
intf-type cr4 autoneg
Set the interface type as CR4 with auto-negotiation enabled.
Syntax
intf-type cr4 autoneg
If you congure intf-type cr4 autoneg, use the no intf-type cr4 autoneg command to set the
interface type as cr4 with autonegotiation disabled.
Defaults Not congured
Command Modes CONFIGURATION
Supported Modes All Modes
Interfaces 549