Concept Guide
Parameters
interface interface Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
Defaults Not congured.
Command Modes INTERFACE VLAN — (conf-if-vl-n)
Supported Modes Programmable-Mux (PMUX)
Command History
Version Description
9.4(0.0) Supported on the FN I/O Aggregator.
Usage Information Dell Networking OS provides the capability of statically conguring the interface to which a multicast router is
attached. To congure a static connection to the multicast router, enter the ip igmp snooping mrouter
interface command in the VLAN context. The interface to the router must be a part of the VLAN where you
are entering the command.
ip igmp snooping querier
Enable IGMP querier processing for the VLAN interface.
Syntax
ip igmp snooping querier
To disable IGMP querier processing for the VLAN interface, use the no ip igmp snooping querier
command.
Defaults Not congured.
Command Modes INTERFACE VLAN — (conf-if-vl-n)
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
Usage Information This command enables the IGMP switch to send General Queries periodically. This behavior is useful when there is
no multicast router present in the VLAN because the multicast trac is not routed. Assign an IP address to the
VLAN interface for the switch to act as a querier for this VLAN.
530 Internet Group Management Protocol (IGMP)