Concept Guide

pdu Enter the keyword pdu then one of the following Interface keywords and slot/port or
number information:
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
Defaults Disabled.
Command Modes EXEC
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
disable
Globally disable GVRP.
Syntax
disable
To re-enable GVRP, use the no disable command.
Defaults Enabled.
Command Modes CONFIGURATION-GVRP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands
gvrp enable — enables GVRP on physical interfaces and LAGs.
protocol gvrp — access GVRP protocol.
garp timers
Set the intervals (in milliseconds) for sending GARP messages.
Syntax
garp timers {join | leave | leave-all}
To return to the previous setting, use the no garp timers {join | leave | leave-all} command.
Parameters
join Enter the keyword join then the number of milliseconds to congure the join time. The
range is from 100 to 147483647 milliseconds. The default is 200 milliseconds.
516 GARP VLAN Registration (GVRP)