Concept Guide

Parameters
source-interface
interface
Enter the keyword source-interface then the type of interface and the interface
information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet then the
slot/plot information.
•
For a 10-Gigabit Ethernet information, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet information, enter the keyword
FortyGigabitEthernet then the slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a Tunnel interface, enter the keyword tunnel then the tunnel ID. The range is
from 1 to 16383.
• For a port channel interface, enter thee keyword port-channel then a number.
The range is from 1 to 128.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults Disabled
Command Modes
• CONFIGURATION
• INTERFACE
Supported Modes Full–Switch
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.14(1.0) Introduced on the C9010, MXL, FN IOM, S3100 series, S4810, S4820T, S3048–ON,
S4048–ON, S4048T-ON, S5048F-ON, S6000, S6000–ON, S6010–ON, S6100–ON, and
Z9100–ON.
Related Commands
• ip dhcp relay source-interface— Congure DHCP relay source IP interface.
ip dhcp snooping
Enable DHCP snooping globally.
Syntax
[no] ip dhcp snooping
Defaults Disabled
Command Modes CONFIGURATION
Supported Modes Full–Switch
Dynamic Host Conguration Protocol 459