Concept Guide
Defaults Disabled
Command Modes INTERFACE VLAN
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands arp inspection-trust — species a port as trusted so that ARP frames are not validated against the binding table.
arp inspection-limit
Congure dynamic ARP inspection rate-limit to verify the rate of ARP packet received in a port on a specic interval.
Syntax
arp inspection-limit {rate pps [interval seconds]}
Defaults None
Command Modes INTERFACE CONFIGURATION
Supported Modes Full-Switch
Parameters
rate pps Enter the keyword rate then the packet per second (pps) value. The range is from 1 to
2048. The default is 15.
interval seconds (Optional) Enter the keyword intervalthen the burst interval in seconds. The range is
from 1 to 15. The default is 1.
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.14(1.0) Introduced on the S3048-ON, S4048-ON, S4048T-ON, S3100 Series, Z9100-ON, S6100-
ON, S6000, S6000-ON, S6010-ON, S5048F-ON, S4810, S4820T, FN IOM and MXL.
arp inspection-trust
Specify a port as trusted so that ARP frames are not validated against the binding table.
Syntax
arp inspection-trust
Defaults Disabled
Command Modes
• INTERFACE
• INTERFACE PORT-CHANNEL
Supported Modes Full–Switch
456 Dynamic Host Conguration Protocol