Concept Guide

cam-optimization
Optimize CAM utilization for QoS Entries by minimizing require policy-map CAM space.
Syntax
cam-optimization [qos]
Parameters
qos Optimize CAM usage for QoS.
Defaults Disabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information When you enable this command, if a Policy Map containing classication rules (ACL and/or dscp/ ip-precedence
rules) is applied to more than one physical interface on the same port pipe, only a single copy of the policy is
written (only one FP entry is used).
NOTE: An ACL itself may still require more that a single FP entry, regardless of the number of interfaces.
For more information, refer to the IP Access Control Lists , Prex Lists , and Route-map sections in the
Dell Networking Operating System Conguration Guide .
cam-threshold
Congure CAM threshold value for sending the syslog message on CAM usage. Congure silence period for stop receiving syslog message
on CAM usage.
Syntax
cam-threshold threshold {default | threshold-percent} silence-period {default |
silence-period-value}
NOTE:
This command is applicable only in Full-Switch mode.
Defaults
Enabled
Parameters
threshold default
Enter the keyword default for CAM usage threshold for notication of the CAM usage
through syslog message. The default threshold value is 90 percent.
threshold
threshold-percent
Enter the threshold percent for notication of the CAM usage through syslog message.
The range is from 1 to 100 percent.
Content Addressable Memory (CAM) 381