Concept Guide

debug ip bgp ipv6 unicast soft-reconguration
Enable soft-reconguration debugging for IPv6 unicast routes.
Syntax
debug ip bgp [ipv4-address | ipv6-address | peer-group-name] ipv6 unicast soft-
reconfiguration
To disable debugging, use the no debug ip bgp [ipv4-address | ipv6-address | peer-group-
name] ipv6 unicast soft-reconfiguration command.
Parameters
ipv4-address | ipv6-
address
Enter the IP address of the neighbor on which you want to enable soft-reconguration
debugging.
peer-group-name Enter the name of the peer group on which you want to enable soft-reconguration
debugging.
ipv6 unicast Debug soft reconguration for IPv6 unicast routes.
Defaults Disabled.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
This command turns on BGP soft-reconguration inbound debugging for IPv6 unicast routes. If no neighbor is
specied, debug is turned on for all neighbors.
ipv6 prex-list
Congure an IPv6 prex list.
Syntax
ipv6 prefix-list prefix-list name
Parameters
prex-list name Enter the name of the prex list.
NOTE: There is a 140-character limit for prex list names.
Defaults none
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
Border Gateway Protocol IPv4 (BGPv4) 373