Concept Guide

debug ip bgp soft-reconguration
Enable soft-reconguration debug.
Syntax
debug ip bgp {ip-address | peer-group-name} soft-reconfiguration
To disable, use the no debug ip bgp {ip-address | peer-group-name} soft-
reconfiguration command.
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted decimal format.
peer-group-name (OPTIONAL) Enter the name of the peer group to disable or enable all routers within the
peer group..
Defaults Disabled
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
This command turns on BGP soft-reconguration inbound debugging. If no neighbor is specied, debug turns on
for all neighbors.
debug ip bgp updates
Allows you to view information about BGP updates.
Syntax
debug ip bgp updates [in | out | prefix-list prefix-list-name]
To disable debugging, use the no debug ip bgp [ip-address | peer-group peer-group-name]
updates [in | out] command.
Parameters
in (OPTIONAL) Enter the keyword in to view only BGP updates received from neighbors.
out (OPTIONAL) Enter the keyword out to view only BGP updates sent to neighbors.
prex-list prex-list-
name
(OPTIONAL) Enter the keyword prefix-list then the name of an established prex
list. If the prex list is not congured, the default is permit (to allow all routes).
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted decimal format.
peer-group-name (OPTIONAL) Enter the name of the peer group to disable or enable all routers within the
peer group.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Border Gateway Protocol IPv4 (BGPv4) 313