Concept Guide

multiplier value Enter the keyword multiplier to specify the number of packets that must be missed
in order to declare a session down. The range is from 3 to 50. The default is 3.
role [active |
passive]
Enter the role that the local system assumes:
• Active — The active system initiates the BFD session. Both systems can be active
for the same session.
• Passive — The passive system does not initiate a session. It only responds to a
request for session initialization from the active system.
The default is Active.
Defaults See Parameters
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
isis bfd all-neighbors
Enable BFD on all IS-IS neighbors discovered on an interface.
Syntax
isis bfd all-neighbors [disable | [interval interval min_rx min_rx multiplier
value role {active | passive}]]
To remove all BFD sessions with IS-IS neighbors discovered on this interface, use the no isis bfd all-
neighbors [disable | [interval interval min_rx min_rx multiplier value role
{active | passive}]] command.
Parameters
disable (OPTIONAL) Enter the keyword disable to disable BFD on this interface.
interval milliseconds (OPTIONAL) Enter the keywords interval to specify non-default BFD session
parameters beginning with the transmission interval. The range is from 50 to 1000. The
default is 200.
min_rx milliseconds Enter the keywords min_rx to specify the minimum rate at which the local system would
like to receive control packets from the remote system. The range is from 50 to 1000. The
default is 200.
multiplier value Enter the keywords multiplier to specify the number of packets that must be missed
in order to declare a session down. The range is from 3 to 50. The default is 3.
role [active |
passive]
Enter the role that the local system assumes:
• Active — The active system initiates the BFD session. Both systems can be active
for the same session.
• Passive — The passive system does not initiate a session. It only responds to a
request for session initialization from the active system.
Bidirectional Forwarding Detection (BFD) 283