Concept Guide

vrrp delay minimum
Set the delay time for VRRP initialization after an interface comes up.
Syntax
vrrp delay minimum seconds
Parameters
seconds Enter the number of seconds for the delay for VRRP initialization after an interface
becomes operational. The range is from 0 to 900 (0 indicates no delay).
Defaults 0
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
This command applies to a single interface. When used with the vrrp delay reload CLI, the later timer rules
the VRRP enabling. For example, if vrrp delay reload is 600 and the vrrp delay minimum is 300:
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that are up
and congured for VRRP.
• When an interface comes up, whether as part of a system reload or an interface reload, the system waits 300
seconds (5 minutes) to bring up VRRP on that interface.
Related Command vrrp delay reload — sets the delay time for VRRP initialization after a system reboot.
vrrp delay reload
Set the delay time for VRRP initialization after a system reboot.
Syntax
vrrp delay reload seconds
Parameters
seconds Enter the number of seconds for the delay. The range is from 0 to 900 (0 indicates no
delay).
Defaults 0
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Virtual Router Redundancy Protocol (VRRP) 1391