Concept Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information When you enter the traceroute command without specifying an IP address (Extended Traceroute), you are
prompted for a target and source IP address, timeout in seconds (default is 5), a probe count (default is 3),
minimum TTL (default is 1), maximum TTL (default is 30), and port number (default is 33434). To keep the default
setting for those parameters, press the ENTER key.
Example (IPv4)
Dell#traceroute www.force10networks.com
Translating "www.force10networks.com"...domain server (10.11.0.1)
[OK]
Type Ctrl-C to abort.
---------------------------------------------------
Tracing the route to www.force10networks.com (10.11.84.18),
30 hops max, 40 byte packets
----------------------------------------------------
TTL Hostname Probe1 Probe2 Probe3
1 10.11.199.190 001.000 ms 001.000 ms 002.000 ms
2 gwegress-sjc-02.force10networks.com (10.11.30.126)
005.000 ms 001.000 ms 001.000 ms
3 fw-sjc-01.force10networks.com (10.11.127.254)
000.000 ms 000.000 ms 000.000 ms
4 www.force10networks.com (10.11.84.18)
000.000 ms 000.000 ms 000.000 ms
Dell#
Related Commands
undebug all
Disable all debug operations on the system.
Syntax
undebug all
Defaults none
Command Modes
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
virtual-ip
Congure a virtual IP address for the active management interface. You can congure virtual addresses both for IPv4 independently.
Syntax
virtual-ip {ipv4-address}
Parameters
ipv4-address Enter the IP address of the active management interface in a dotted decimal format
(A.B.C.D.).
134 Control and Monitoring