Concept Guide
• For VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For the Management interface, enter the keyword ManagementEthernet then
slot/port information.
This option is valid only in Full-Switch mode.
Defaults Not congured.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
ntp trusted-key
Set a key to authenticate the system to which NTP synchronizes.
Syntax
ntp trusted-key number
To delete the key, use the no ntp trusted-key number command.
Parameters
number Enter a number as the trusted key ID. The range is from 1 to 65534.
Defaults Not congured.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.14(0.0) The trusted-key range value is increased from 1 to 65534.
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The number parameter in the ntp trusted-key command must be the same number as the number
parameter in the ntp authentication-key command. If you change the ntp authentication-key
command, you must also change the ntp trusted-key command.
Related Commands
ntp authentication-key — sets an authentication key for NTP.
ntp authenticate — enables the NTP authentication parameters you set.
show clock
Displays the current clock settings.
Syntax
show clock [detail]
System Time 1325