Concept Guide

Command History
Version Description
9.14(0.0) Introduced on the C9010, FN–IOM, MIOA, MXL, S3048–ON, S4048–ON, S4048T-ON,
S5048F-ON, S6000, S6000–ON, S6010-ON, S6100–ON, and Z9100–ON.
ntp oset-threshold
Congure the threshold time interval before which the system generates an NTP audit log message if the time dierence from the NTP
server is greater than a threshold value (oset-threshold).
Syntax
ntp offset-threshold threshold-value
To disable the threshold value, use the no ntp offset-threshold command.
Parameters
oset-threshold
threshold-value
(Optional) Enter the keyword offset-threshold and then the threshold value. The
range is from 0 to 999.
Defaults Zero (0).
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S3038–ON, S4048-ON, S3100 Series, S4810P, S4820T, S5000,
S6000, S6000–ON, S6100–ON, Z9500, and Z9100–ON.
Usage Information
The ntp offset-threshold command does not time synchronization.
Example
DellEMC(config)# ntp offset-threshold 4
ntp server
Congure an NTP time-serving host.
Syntax
ntp server {ipv4-address}
Parameters
ipv4-address Enter an IPv4 address (A.B.C.D).
Defaults Not congured.
Command Modes CONFIGURATION
Supported Modes All Modes
1320 System Time