Concept Guide

To disable multicast storm control on the interface, use the no storm-control multicast
packets_per_second in command.
Parameters
packets_per_secon
d
Enter the packets per second of broadcast trac allowed into the network. The range is
from 0 to 33554368.
Command Modes INTERFACE (conf-if-interface-slot/port)
Supported Modes Programmable-Mux (PMUX)
Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Supported on the M I/O Aggregator.
storm-control broadcast (Conguration)
Congure the percentage of broadcast trac allowed in the network.
Syntax
storm-control broadcast [packets_per_second in]
To disable broadcast rate-limiting, use the no storm-control broadcast [packets_per_second in]
command.
Parameters
packets_per_secon
d
Enter the packets per second of broadcast trac allowed into the network. The range is
from 0 to 33554368.
Defaults none
Command Modes CONFIGURATION (conf)
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Broadcast storm control is valid on Layer 2/Layer 3 interfaces only. Layer 2 broadcast trac is treated as
unknown-unicast trac.
storm-control broadcast (Interface)
Congure the percentage of broadcast trac allowed on an interface.
Syntax
storm-control broadcast [packets_per_second in]
1280 Storm Control