Concept Guide

Unit Boot-Mode Next-Boot
------------------------------------------------
0 stack stack
1 stack stack
2 stack stack
3 stack stack
4 Not Present
5 Not Present
Dell#
show system stack-unit stack-group
Displays the stack-groups present/congured for a FN I/O Aggregator stack unit.
Syntax
show system stack-unit unit-number stack-group [configured]
Parameters
unit number <0–5> Enter the number of the member stack unit. The range is from 0 to 5.
Defaults none
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.6.(0.0) Supported on the FN I/O Aggregator.
Usage Information This command is supported on the M I/O, FN410S, and FN410T Aggregators.
Example
Dell#show system stack-unit 0 stack-group ?
configured Configured stack groups
| Pipe through a command
<cr>
Dell#show system stack-unit 0 stack-group configured
Configured stack groups in stack-unit 0
Dell#show system stack-unit 0 stack-group
Stack group Ports
------------------------------------
0 0/9
1 0/10
2 0/11
3 0/12
Dell#
Related Commands
reload— reboots the system.
show system— displays the current status of all stack members or a specic member.
stack-unit iom-mode
Toggle the operating mode between programmable multiplex, standalone, stack, full–switch,and VLT modes.
Syntax
stack-unit <unit-number> iom-mode [programmable-mux | stack | standalone | vlt
| full-switch
Stacking Commands 1271