Concept Guide

( 10.11.68.22 )by admin
May 19 12:05:43: %STKUNIT0-M:CP %SYS-5-CONFIG_I: Configured from vty2
( 10.11.68.22 )by admin
May 19 10:23:59: %STKUNIT0-M:CP %SYS-5-CONFIG_I: Configured from vty0
( 10.11.68.22 )by admin
May 19 10:23:58: %STKUNIT0-M:CP %SEC-5-LOGOUT: Exec
--More--
Example (History)
Dell#show logging history
Syslog History Table: 1 maximum table entries,
saving level warnings or higher
SNMP notifications not Enabled
May 22 08:53:09: %STKUNIT0-M:CP %SEC-3-AUTHENTICATION_ENABLE_SUCCESS: Enable
password authentication success on vty0 ( 10.11.68.22 )
Dell#
show logging driverlog stack-unit
Display the driver log for the specied stack member.
Syntax
show logging driverlog stack-unit unit#
Parameters
stack-unit unit# Enter the keywords stack-unit then the stack member ID of the switch for which you
want to display the driver log. The range is from 0 to 1.
defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module..
Usage Information This command displays internal software driver information, which may be useful during troubleshooting switch
initialization errors, such as a downed Port-Pipe.
show logging auditlog
Displays an audit log.
Syntax
show logging auditlog
Defaults none
Command Modes EXEC
Supported Modes
Full–Switch
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Simple Network Management Protocol (SNMP) and Syslog 1263