Concept Guide

snmp trap link-status
Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.
Syntax
snmp trap link-status
To disable sending link trap messages, use the no snmp trap link-status command.
Defaults Enabled.
Command Modes INTERFACE
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information If the interface is expected to ap during normal usage, you could disable this command.
Syslog Commands
The following commands allow you to congure logging functions on all Dell Networking switches.
clear logging
Clear the messages in the logging buer.
Syntax
clear logging
Defaults none
Command Modes EXEC Privilege
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands show logging — displays logging settings and system messages in the internal buer.
default logging buered
Return to the default setting for messages logged to the internal buer.
Syntax
default logging buffered
Defaults size = 40960; level = 7 or debugging
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Simple Network Management Protocol (SNMP) and Syslog 1251