Concept Guide

Parameters
interface Enter the following keywords and slot/port or number information:
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
Defaults The IP address assigned to the management interface is the default.
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To enable this snmp-server trap-source command, congure an IP address on the interface and enable the
interface congured as an SNMP trap source.
Related Commands snmp-server community — sets the community string.
snmp-server user
Congure a new user to an SNMP group.
Syntax
snmp-server user name {group_name remote ip-address udp-port port-number} [1 |
2c | 3] [encrypted] [auth {md5 | sha} auth-password] [priv des56 | aes128–cfb}
priv-password [access access-list-name | ipv6 access-list-name | access-list-
name ipv6 access-list-name]
To remove a user from the SNMP group, use the no snmp-server user name {group_name remote
ip-address udp-port port-number} [1 | 2c | 3] [encrypted] [auth {md5 | sha}
auth-password] [priv des56 | aes128–cfb} priv password] [access access-list-
name | ipv6 access-list-name] command.
Parameters
name Enter the name of the user (not to exceed 20 characters), on the host that connects to
the agent.
group_name Enter a text string (up to 20 characters long) as the name of the group. The following
groups are created for mapping to read/write community/security-names (defaults):
• v1v2creadu — maps to a community with ro permissions.
• 1v2cwriteu — maps to a community rw permissions.
remote ip-address Enter the keywords udp-port then the user datagram protocol (UDP) port number on
the remote device. The range is from 0 to 65535. The default is 162.
udp-port port-
number
Enter the keywords udp-port then the UDP (User Datagram Protocol) port number on
the remote device. The range is from 0 to 65535. The default is 162.
1 | 2c | 3 (OPTIONAL) Enter the security model version number (1, 2c, or 3):
• 1 is the least secure version.
Simple Network Management Protocol (SNMP) and Syslog 1247