Manualshelf

Concept Guide

ManualsBrandsDell ManualsAccess PlatformsFN IO Module
1241124212431244124512461247124812491250
snmp-server location
Congure the location of the SNMP server.
Syntax
snmp-server location text
To delete the SNMP location, use the no snmp-server location command.
Parameters
text Enter an alpha-numeric text string, up to 55 characters long.
Defaults Not congured.
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
snmp-server packetsize
Set the largest SNMP packet size permitted. Wen the SNMP server is receiving a request or generating a reply, use the snmp-server
packetsize global configuration command.
Syntax
snmp-server packetsize byte-count
Parameters
byte-count Enter one of the following values 8, 16, 24 or 32. Packet sizes are 8000 bytes, 16000
bytes, 32000 bytes, and 64000 bytes.
Defaults 8
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
snmp-server trap-source
Congure a specic interface as the source for SNMP trac.
Syntax
snmp-server trap-source interface
To disable sending traps out a specic interface, use the no snmp trap-source command.
1246 Simple Network Management Protocol (SNMP) and Syslog