Concept Guide

• xstp — Notication of a state change in MSTP (802.1s), RSTP (802.1w), and PVST
+.
notication-option For the envmon notication-type, enter one of the following optional parameters:
• temperature
For the snmp notication-type, enter one of the following optional parameters:
• authentication
• coldstart
• linkdown
• linkup
• syslog-reachable
• syslog-unreachable
Defaults Not enabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.8(0.0) Added the following two SNMP notication options: syslog-reachable and
syslog-unreachable.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The system supports up to 16 SNMP trap receivers.
If you do not congure this command, no traps controlled by this command are sent. If you do not specify a
notification-type and notification-option, all traps are enabled.
Related Commands snmp-server community — enables SNMP and sets the community string.
snmp-server engineID
Congure the name for both the local and remote SNMP engines on the router.
Syntax
snmp-server engineID [local engineID] [remote ip-address udp-port port-number
engineID]
To return to the default, use the no snmp-server engineID [local engineID] [remote ip-
address udp-port port-number engineID] command.
Parameters
local engineID
Enter the keyword local then the engine ID number that identies the copy of the
SNMP on the local device.
Format (as specied in RFC 3411): 12 octets.
• The rst four octets are set to the private enterprise number.
Simple Network Management Protocol (SNMP) and Syslog 1241