Concept Guide

Related Commands
ip access-list standard — names (or selects) a standard access list to lter based on IP address.
show running-cong — displays the current SNMP conguration and defaults.
snmp-server contact
Congure contact information for troubleshooting this SNMP node.
Syntax
snmp-server contact text
To delete the SNMP server contact information, use the no snmp-server contact command.
Parameters
text Enter an alphanumeric text string, up to 55 characters long.
Defaults none
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
snmp-server enable traps
Enable SNMP traps.
Syntax
snmp-server enable traps [notification-type] [notification-option]
To disable traps, use the no snmp-server enable traps [notification-type] [notification-
option] command.
Parameters
notication-type Enter the type of notication from the following list:
• ecfm — Notication of changes to ECFM.
• entity — Notication of changes to entity.
• envmon — For Dell Networking device notications when an environmental
threshold is exceeded.
• eoam — Notication of changes to the EOAM state.
• ets — Notication of changes to the ets traps.
• fips — Notication of changes to the FIP snooping state.
• lacp — Notication of changes.
• pfc — Notication of changes to pfc traps.
• snmp — Notication of RFC 1157 traps.
• stp — Notication of a state change in the spanning tree protocol (RFC 1493).
• vrrp — Notication of a state change in a VRRP group.
1240 Simple Network Management Protocol (SNMP) and Syslog