Concept Guide

Version Description
9.13(0.0) Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000, S6010–
ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and MXL.
dynamic-auth-enable
Congure NAS to receive and process dynamic authorization messages.
Syntax
dynamic-auth-enable
To stop NAS from receiving and processing dynamic authorization messages, use the no dynamic-auth-
enable command.
Defaults Disabled.
Command Modes
• CONF-DYNAMIC-AUTH
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
The following is a list of the Dell EMC Networking OS version history for this command.
Version Description
9.14(1.0) Introduced on the S4810 and S4820T.
9.13(0.0) Introduced on the C9010, S3100, S3048–ON, S4048T-ON, S4048–ON, S5000, S6010–
ON, S6000–ON, S6100–ON, S6000, Z9100–ON, Z9500, FN-IOM, and MXL.
Usage Information If this conguration is not enabled, then dynamic authorization messages are not handled by the NAS.
ip radius source-interface
Specify an interface’s IP address as the source IP address for RADIUS connections.
Syntax
ip radius source-interface interface
To delete a source interface, use the no ip radius source-interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a ten-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
•
For VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults Not congured.
Command Modes CONFIGURATION
Security 1175