Concept Guide
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To enable the interface to send both version of RIP packets, use the ip rip send version 1 2 command.
Related Commands
ip rip receive version — sets the RIP version for the interface to receive trac.
version — sets the RIP version for the switch software.
ip split-horizon
Enable split-horizon for RIP data on the interface. As described in RFC 2453, the split-horizon scheme prevents any routes learned over a
specic interface to be sent back out that interface.
Syntax
ip split-horizon
To disable split-horizon, use the no ip split-horizon command.
Defaults Enabled
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands ip poison-reverse — sets the prex for RIP routing updates.
maximum-paths
Set RIP to forward packets over multiple paths.
Syntax
maximum-paths number
To return to the default values, use the no maximum-paths commands.
Parameters
number Enter the number of paths. The range is from 1 to 16. The default is 4 paths.
Defaults 4
Command Modes ROUTER RIP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Routing Information Protocol (RIP) 1113