Concept Guide

Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
NOTE: Per port rate police is supported for Layer 2 tagged and untagged switched trac and for Layer 3
trac. Per VLAN rate police is supported on only tagged ports with Layer 2 switched trac.
On one interface, you can congure the rate police command for a VLAN or you can congure the rate
police command for an interface. For each physical interface, you can congure three rate police
commands specifying dierent VLANS.
For each physical interface, you can congure three rate police commands specifying dierent VLANs.
Related Commands
rate-police — species trac policing on the selected interface.
rate-shape
Shape the trac output on the selected interface.
Syntax
rate shape [kbps] rate [burst-KB]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits per second (Kbps). Make the
following value a multiple of 64. The range is from 0 to 40000000. The default granularity
is Megabits per second (Mbps).
rate Enter the outgoing rate in multiples of 10 Mbps. The range is from 10 to 10000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 0 to 10000. The default is 50.
Defaults Granularity for rate is Mbps unless you use the kbps option.
Command Modes QOS-POLICY-OUT
Supported Modes Programmable-Mux (PMUX)
Full-Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information When you apply rate-shape in QoS policy both on the Queue Level and in Aggregate mode, the queue-based
shaping occurs rst then aggregate rate shaping.
Quality of Service (QoS) 1069