Concept Guide

Usage Information The following describes the show ip pim snooping neighbor commands shown in the following example.
Field Description
Neighbor address Displays the IP address of the neighbor learned through PIM-SM snooping.
Interface Displays the VLAN ID number and slot/port on which the PIM-SM-enabled neighbor was
discovered.
Uptime/expires Displays the amount of time the neighbor has been up then the amount of time until the
neighbor is removed from the multicast routing table (that is, until the neighbor hold time
expires).
Ver Displays the PIM version number:
• v2 = PIM version 2
DR prio/Mode Displays the Designated Router priority and the mode:
• 1 = default Designated Router priority (use the ip pim dr-priority command)
• DR = Designated Router
• S = Sparse mode
Example
Dell#show ip pim snooping neighbor
Neighbor Interface Uptime/Expires Ver DR Prio
Address
165.87.32.2 Vl 2 [tei 4/8 ] 00:04:03/00:01:42 v2 1
165.87.32.10 Vl 2 [te 4/8 ] 00:00:46/00:01:29 v2 0
165.87.32.12 Vl 2 [te 4/8 ] 00:00:51/00:01:24 v2 0
show ip pim snooping tib
Display information from the tree information base (TIB) PIM-SM snooping discovered about multicast group members and states.
Syntax
show ip pim snooping tib [vlan vlan-id] [group-address [source-address]]
Parameters
vlan vlan-id (OPTIONAL) Enter a VLAN ID to display TIB information PIM-SM snooping discovered on
a specied VLAN. The valid VLAN IDs range is from 1 to 4094.
group-address (OPTIONAL) Enter the group address in dotted decimal format (A.B.C.D) to display TIB
information PIM-SM snooping discovered for a specied multicast group.
source-address (OPTIONAL) Enter the source address in dotted decimal format (A.B.C.D) to display TIB
information PIM-SM snooping discovered for a specied multicast source.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full—Swtich
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
1024 PIM-Sparse Mode (PIM-SM)