CLI Guide

debug ip msdp
Turn on MSDP debugging.
Syntax
debug ip msdp {event peer address | packet peer address | pim}
To turn debugging off, use the no debug ip msdp {event peer address |
packet peer address | pim} command.
Parameters
event peer
address
Enter the keyword event then the peer address in a dotted
decimal format (A.B.C.D.).
packet peer
address
Enter the keyword packet then the peer address in a dotted
decimal format (A.B.C.D.).
pim Enter the keyword pim to debug advertisement from PIM.
Defaults Not configured.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
ip msdp cache-rejected-sa
Enable an MSDP cache for the rejected source-active entries.
Syntax
ip msdp cache-rejected-sa {number}
To clear the MSDP rejected source-active entries, use the no ip msdp cache-
rejected-sa {number} command then the ip msdp cache-rejected-sa
{
number} command.
Parameters
number Enter the number of rejected SA entries to cache. The range
is from 0 to 32766.
Defaults none
Command Modes CONFIGURATION
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Supported Modes Full–Switch
Multicast Source Discovery Protocol (MSDP)
999