CLI Guide

layer2_priority Enter the Layer 2 priority. The range is from 0 to 7.
DSCP_value Enter the DSCP value. The range is from 0 to 63.
priority-tagged
number
Enter the keywords priority-tagged then the Layer 2
priority. The range is from 0 to 7.
Defaults unconfigured.
Command Modes CONFIGURATION (conf-lldp)
Supported Modes Full-Switch
Command History
9.9(0.0) Introduced on the FN IOM.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
show running-config lldp — displays the LLDP running configuration.
advertise med location-identification
To advertise a location identifier, configure the system.
Syntax
advertise med location-identification {coordinate-based value |
civic-based value | ecs-elin value}
To return to the default, use the no advertise med location-
identification {coordinate-based value | civic-based value |
ecs-elin value} command.
Parameters
coordinate-based
value
Enter the keywords coordinate-based then the
coordinated based location in hexadecimal value of 16
bytes.
civic-based value Enter the keywords civic-based then the civic based
location in hexadecimal format. The range is from 6 to 255
bytes.
ecs-elin value Enter the keywords ecs-elin then the Emergency Call
Service (ecs) Emergency Location Identification Number
(elin) numeric location string. The range is from 10 to 25
characters.
Defaults unconfigured.
Command Modes CONFIGURATION (conf-lldp)
Supported Modes Full-Switch
986
Link Layer Discovery Protocol (LLDP)