CLI Guide

To return to the global LLDP configuration mode, use the no protocol lldp
command from Interface mode.
Defaults Enabled
Command Modes INTERFACE (conf-if-interface-lldp)
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
This command is available only in PMUX mode.
By default, protocol lldp is enabled, To disable, use the no protocol lldp
command.
When you enter the LLDP protocol in the Interface context, it overrides global
configurations. When you execute the no protocol lldp from INTERFACE
mode, interfaces begin to inherit the configuration from global LLDP
CONFIGURATION mode.
show lldp neighbors
Display LLDP neighbor information for all interfaces or a specified interface.
Syntax
show lldp neighbors [interface] [detail]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet then the slot/port information.
detail (OPTIONAL) Enter the keyword detail to display all the TLV
information, timers, and LLDP tx and rx counters.
Defaults none
Command Modes EXEC Privilege
Supported Modes All Modes
982
Link Layer Discovery Protocol (LLDP)